Installing your Whiteboard

Installation guide

Get your board set up, following our easy step-by-step guide!

Step One		Position the whiteboard on the wall. Using a level check that it is level. Mark the wall where the fixings will go, using the holes in the glass as a guide.
Step Two		Drill holes in the wall using an 8mm drill bit.
Step Three		Hammer the tip of the wall mates into each hole. Screw the wall mate in until firm.
Step Four		Remove threaded screw and discard.
Step Five		Install Standoff Fixings by screwing the long threaded rod into the wall mate by hand.
Step Six		Position the holes in the whiteboard over the fixings and secure the whiteboard on the wall. Screw the fixing cap onto the thread that is projecting from each hole and tighten.